The ribbing comes from working in the back loop only, which makes stretchy vertical ridges. Each leg warmer is a rectangle worked sideways, then seamed into a tube.
The photo is an illustration of the finished piece. Sizes and yarn amounts are estimates: your yarn, hook and tension will change the result, so check your counts after each round.
What you need
- Worsted wool blend in plum (about 220 m for an adult pair)
- 5 mm hook, tapestry needle, tape measure
Sizing
The starting chain sets the height (about 35 cm). The number of rows sets the width around the leg: measure the widest part of the calf and subtract 3–4 cm so the leg warmer hugs the leg. The pattern below gives about 30 cm around.
Abbreviations (US terms)
ch = chain, sc = single crochet, hdc = half double crochet, dc = double crochet, sl st = slip stitch, inc = 2 sc in the same stitch, dec = invisible decrease (sc2tog through front loops), MR = magic ring, BLO = back loop only, FO = fasten off. The number in brackets is the stitch count at the end of the round or row.
Pattern (make 2)
- Row 1: ch 61, hdc in 3rd ch from hook and across (59). Ch 1, turn.
- Row 2: hdc BLO in each st across (59). Ch 1, turn.
- Repeat row 2 until the piece measures your calf width minus 3–4 cm (about 44 rows).
- FO, leaving a 60 cm tail.
Finishing
Fold the rectangle so the first and last rows meet. Whipstitch or sl st them together through the loops. Turn right side out and weave in the ends.
Tips
- Make a 10 cm swatch first: count rows per 10 cm and adjust.
- Wool blends keep their stretch better than pure acrylic.
